|Job Ref:||204590165||Employer:||cv-library.co.uk||Industry:||Civil and Structural||Job Type:||Permanent||Country:||United Kingdom||County/State:||Staffordshire||City:||Burton upon Trent||Address:||Post Date:||23/10/2016 09:02|
My client is looking for 2 CNC and Manual Lathe engineers in Burton-On-Trent and the surrounding areas.|
Applicants would are preferably to be experienced in using:
• CNC Lathe with Haas controls
• CNC Millers with Heidenhein controls
• Manual Lathes
• Manual Millers
• Bridgeport CNC machines
In addition to the above, welding, fabrication and site fitting/steel erecting is required as onsite installation will happen from time to time.
Although my client would prefer an experienced engineer, they are open to taking on someone with little experience and training them up on every machine both CNC and Manual with the addition of putting you through some training course as well.
In order to be considered for the inexperienced role you must show 100% commitment and lots of enthusiasm, do this will open the door to a new career with all training given.
Shift are the same each week, these being:
Monday - Thursday: 8:00-4:30pm
Total of 39 hours per week with possible overtime paying at time and a half.
Hourly rates are dependent on experience and knowledge